N/A For Industrial Use Only.

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combination for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLAST DIP INTERNATIONAL technical service.

Performix and logo are registered trademarks of PLASTI DIP INTERNATIONAL

N/A Wires, terminals or all other surfaces must be clean, dry, and free of all oils, grease, wax and loose rust.

MIX WELL BEFORE USE. USE ADEQUATE VENTILATION:
Stir gently with brush applicator cap to avoid producing bubbles before each use. Apply wet overlapping coats. Allow 10-20 minutes dry time (dry to the touch) before applying additional coats to desired thickness. A minimum of 2-3 coats are recommended for best results. Allow 24 hours to fully cure.

N/A Allow 4 hours dry time per coat before use. Allow overnight drying whenever possible. Avoid excessive air movement, heat or humidity. Minimal 2 coats required (5+ mils) to assure good dielectric protection. Always use proper ventilation and protection.

N/A Turn off power before starting electrical work and follow your local electrical codes.